Let us Prepare you for the cold weather in Woodland Hills, CA
$139 Heater Tune-up
Winter time is here, residents and businesses in the Woodland Hills, CA area are preparing for this up and coming COLD WINTER TIME. Before sliding your thermostat to HEAT it is recommended to have your Heater serviced to prevent costly Heater Repairs in Woodland Hills. A little bit of preventative maintenance will help ensure your heater is running safe and to manufacturer specs.
PACIFIC COAST is running a Winter special in Woodland Hills, $139 for a complete Heater Service Tune-up. This annual Heating maintenance will make sure your furnace is running Efficiently and SAFE. Regular maintenance save homeowners money on unwanted repairs, which usually occur on the coolest nights, when the system is at maximum use.
During a tune-up minor repairs can be made, preventing expensive replacements in the future. Scheduled maintenance will guarantee your Heater will run safely while at optimum efficiency. Dirty filters and components cause your Heating system to work HARDER and OVER HEAT. Raising utility bills and costing homeowners more money.
Our service technicians will perform a 20 point professional check up of your Furnace takes approximately 60-90 minutes for our technicians to perform. The Heater tune-up involves checking that all components are functioning properly and cleaning of the Heating system. We are available for 24 hour emergency Heater Repair in Woodland Hills.
 Clean or replace 1″ filters as needed | Tighten all electrical connections |
| Check for proper thermostat function | Inspect safety devices and Gas Valve for proper operation |
| Monitor volts/amps on Blower motor | Inspect electrical for exposed wiring |
| Inspect blower motor for bearing wear | Check for Carbon Monoxide |
| Take amperage reading on blower motor | Heat exchanger camera inspection |
| Test blower motor capacitor | Check for gas leakage |
| Check blower motor bearings | Measure temperature difference-supply/return |
| Check blower for proper speed | Inspect duct work for energy loss |
| Inspect blower / Return air flow | Measure and adjust gas pressure to manufacturer specifications |
| Vacuum blower compartment | Test ignition system for proper operation |